K-Tuned Swivel Neck Thermostat Housing
Introducing from K-Tuned.com the solution to your lower rad hose problems. Most motors we receive have the lower water neck on the thermostat housing broken off. You can't order it from Honda/Acura because they only want to sell you the whole housing thermostat and all which is really expensive and still doesn't provide any flexibility. If yours isn't broken then you have to try and get the right hose with the right angles on it to mate to the rad. Even after you have that sorted out you then have to figure out where to put your fan switch. In the past the only choice was an inline aluminum coupler, which sometimes works out.
This new product solves a whole host of problems and gives you a lot of flexibility with your swap. The housing swivels allowing you to index it to whatever position you need before you tighten it down. The custom made provided fitting is the exact same size as your oem rad and is also an -AN thread so you can swap it out for whatever sized fitting that fits your install. If you are running a braded hose with -AN fittings this housing will allow for an easy bolt on and screw in installation. It has three ports in the body for your fan switch, two auxiliary 1/8 NPT for gauges etc. It comes with a Stant stock temp thermostat and provided "C" clip. By now having a standard size thermostat you can replace the stat with anything from 170-195deg.
Last but not least, this was a bonus from when we were building it. We noticed that adding one more hole to our flange you can remove the whole stock black housing off your block for race use only. Our whole unit will bolt directly to the aluminum water pump housing. Perfect for race car applications.
- Angle you rad hose any way you want
- Uses standard thermostat you can change
- Includes all hardware needed
- Includes Thermostat & C clip
- Replaces useless plastic thermostat housing
*All prices include shipping!*
